Maytag MVWP475EW オーナーマニュアル

ページ / 36
15
TROUBLESHOOTING
If you experience
Possible Causes
Solution
Washer not performing as expected (cont.)
Fabric damage
Sharp items were in pockets during 
wash cycle.
Empty pockets, zip zippers, and snap or hook fasteners before 
washing to avoid snags and tears.
Strings and straps could have 
tangled.
Tie all strings and straps before starting wash load.
Items may have been damaged 
before washing.
Mend rips and broken threads in seams before washing.
Fabric damage can occur if load is 
tightly packed.
Load garments in loose heaps evenly around the basket wall.  
Load with dry items only.
Use cycle designed for the fabrics being washed.
Use Bulky/Sheets or Deep Water Wash cycle for higher water fill. See 
“What’s New under the Lid” and “Cycle Guide” to match your load with 
the best cycle.
Add only 1 or 2 additional garments after washer has started.
Liquid chlorine bleach may have 
been added incorrectly.
Do not pour liquid chlorine bleach directly onto load. Wipe up 
bleach spills.
Undiluted bleach will damage fabrics. Do not use more than  
recommended by manufacturer.
Do not place load items on top of bleach dispenser when  
loading and unloading washer.
Garment care instructions may not 
have been followed.
Always read and follow garment manufacturer’s care label  
instructions. See the “Cycle Guide” to match your load with  
the best cycle.
Odors
Monthly maintenance not done as  
recommended.
See “Cleaning Your Washer” in Washer Maintenance.
Unload washer as soon as cycle is complete.
Using too much detergent.
Be sure to measure correctly. Always follow the manufacturer’s 
directions.
See “Cleaning your Washer” section.
Lid locked light is 
flashing
The lid is not closed.
Close the lid. The washer will not start with the lid open.
A cycle was stopped or paused 
using the Start/Pause button.
The washer may still be spinning. The lid will not unlock until the 
basket has stopped spinning. This may take several minutes if  
washing large loads or heavy fabrics.
Single-dose laundry packet 
not dissolving
Adding laundry packet incorrectly.
Be sure laundry packet is added to washer basket before adding 
clothes. Follow the manufacturer’s instructions to avoid damage to 
your garments.
Washer pumps out water 
before finishing cycle
Lid is left open for more than  
10 minutes.
Make sure lid is closed before starting a cycle and/or during 
prewash (soak).
First try the solutions suggested here or visit our website at www.maytag.com/product_help - 
In Canada www.maytag.ca for assistance and to possibly avoid a service call.