Whirlpool CSP2860TQ インストール手順

ページ / 48
7
Your dryer can be installed in a basement, laundry room,  
or recessed area.
Companion appliance location requirements should also  
be considered.
IMPORTANT: 
 
Do not install or store the dryer where it will be exposed  
to the weather. Proper installation is your responsibility.
 
This dryer must not be installed in a closet with a door.
You will need:
 
 A grounded electrical outlet located within 6 ft. (1.8 m) of 
where the power cord is attached to the back of the dryer. 
See “Electrical Requirements.”
 
 A level floor with a maximum slope of 1" (25 mm) under 
entire dryer. Installing the dryer on soft floor surfaces, 
such as carpets or surfaces with foam backing, is not 
recommended.
Dryer installation clearances
 
  The location must be large enough to allow the dryer door  
to be fully opened.
 
Additional spacing should be considered for ease of 
installation and servicing. The door opens more than 180°.
 
Additional clearances might be required for wall, door,  
and floor moldings.
 
  Additional spacing of 1" (25 mm) on all sides of the dryer  
is recommended to reduce noise transfer.
LOCATION REQUIREMENTS
When installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances. 
 
Check code requirements: Some codes limit or do not  
permit installation of clothes dryers in garages, closets,  
or sleeping quarters. Contact your local building inspector.
 
 Make sure that lower edges of the cabinet, plus the back 
and bottom sides of the dryer, are free of obstructions to 
permit adequate clearance of air openings for combustion 
air. See “Recessed Area Installation Instructions” below  
for minimum spacing requirements.
Recessed Area Installation Instructions
This dryer may be installed in a recessed area. For recessed 
area installations, minimum clearances can be found on the 
warning label on the rear of the dryer or in “Dimensions/
Clearances.”
The installation spacing is in inches and is the minimum 
allowable. Additional spacing should be considered for ease  
of installation, servicing, and compliance with local codes  
and ordinances.
The dryer must be exhausted outdoors.