Movincool CLASSICPLUS14 操作ガイド
11
INSTALLATION (cont.)
Plugging in the Unit
1. Check the prongs and surface of the power cord plug for dust/dirt. If dust and/
or dirt are present, wipe off with a clean, dry cloth.
2. Check the power cord, plug and prongs for damage or excess play. If any
damage or excess play is found, contact your MovinCool reseller or a qualified
technician for repair.
WARNING:
1. If the power cord or plug is damaged, repair should only be
performed by qualified electrical personnel.
2. Do not connect/disconnect the power cord or attempt to operate
buttons with wet hands. This could result in electrical shock.
CAUTION:
1. Classic Plus 14 ONLY: The AC outlet (115 VAC Single Phase, 60 Hz)
needs to be rated at 15 A or higher. Do not share the outlet with any
other instrument or equipment.
2. Classic Plus 26 ONLY: The AC outlet (208/230 VAC Single Phase,
60 Hz) needs to be rated at 20 A or higher. Do not share the outlet
with any other instrument or equipment.
Note:
1. Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign
1. Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign
matter.
2. The Classic Plus 14 is equipped with a UL approved LCDI cord and an
approved NEMA plug configuration (5-15). The appropriate outlet must be
used for this plug type.
3. The Classic Plus 26 is equipped with a UL approved LCDI cord and an
approved NEMA plug configuration (6-20). The appropriate outlet must be
used for this plug type.