Maytag MES8880DS インストールガイド

4. Use a Phillips screwdriver to connect the green ground wire 

from the power supply cord to the range with the ground-link 
screw and ground-link section. The ground wire must be 
attached over the ground-link section.

5. Use 

³⁄₈" (1.0 cm) nut driver to connect the neutral (white) wire 

to the center terminal block post with one of the 10-32 hex 
nuts.

6. Connect line 2 (red) and line 1 (black) wires to the outer 

terminal block posts with 10-32 hex nuts.

7. Firmly tighten hex nuts.

NOTE: For power supply cord replacement, use only a power 
cord rated at 250 volts minimum, 40- or 50-amps that is 
marked for use with nominal 1

³⁄₈" (3.5 cm) diameter 

connection opening, with ring terminals and marked for use 
with ranges.

8. Tighten strain relief screws.

IMPORTANT: Verify the tightness of the hex nuts.

9. Replace lower access cover.

1. Disconnect power.

2. Remove the lower access cover screws located on the back 

of the range. Pull the bottom of the cover toward you and out 
to remove cover from range. 

3. Remove plastic tag holding three 10-32 hex nuts from the 

middle post of the terminal block.

A

B

C

F

D

E

A

B

C