Lynx L54PSR2NG オーナーマニュアル
34
GAS
G
G
CONNECTIONS
the grill is factory set to use
either propane (lp) or natural
gas (
either pr
either pr
nat).
opane (
opane (
it is critical that the
opane (
opane (
gas you use matches that
which the grill was set up for.
gas you use matches that
gas you use matches that
you can verify that by
which the grill was set up for.
which the grill was set up for.
yy
checking the
rating plate
.
the rating plate is located in
one or more of the following
he rating plate is located in
he rating plate is located in
places:
attached to the underside
of the drip tray
on the heat shield behind
on the heat shield behind
the front panel
on the inside left cabinet
on the inside left cabinet
wall
one is underneath the drip tray.
model numbers and gas type.
model numbers and gas type.
ensure that the gas supplied
meets with the minimum
nsure that the gas supplied
nsure that the gas supplied
pressure requirements. Do not
operate the grill on any gas
pr
pressure requirements. Do not
essure requirements. Do not
other than that for which the
operate the grill on any gas
operate the grill on any gas
grill has been set.
fuel
wc
max
inlet
wc min
under
full load
nat gas
7 in
4 in
as
7 in
4 in
as
7 in
4 in
lp
14 in
11 in
14 in
11 in
Water Column Requirements
Both the regulator and the
manifold orifices have been
Both the regulator and the
Both the regulator and the
tuned for the type of gas
specified on the rating plate.
tuned for the type of gas
tuned for the type of gas
converting to a different type
of gas requires a conversion
onverting to a different type
onverting to a different type
kit, available from
of gas requires a conversion
of gas requires a conversion
lynx or
ll
from your dealer and must be
installed by a qualified techni
om your dealer and must be
om your dealer and must be
-
cian.
all installation and all instal-
all installation and all instal-
lation parts must conform to
local codes with the
lation parts must conform to
lation parts must conform to
national
lation parts must conform to
lation parts must conform to
electrical code, ansi Z223.1/
nfpa
nfp
nfp 70 latest edition and
the national fuel gas code,
ansi Z223.1/nfpa 54 in the
u.s and cga-B149.1/.2 in
canada.
canadian installations must
canadian installations must
conform to cga-B149.1/.2
natural gas/propane installa-
tion code. (
natural gas/propane installa-
natural gas/propane installa-
c
natural gas/propane installa-
natural gas/propane installa-
anada)
natural gas/propane installa-
natural gas/propane installa-
natural gas
lynx r
ll
ecommends that
only qualified profession
ynx r
ynx r
-
als perform the required
only qualified profession
only qualified profession
plumbing on this product.
als perform the required
als perform the required
to ensur
tt
e satisfactory per-
formance, the gas supply
e satisfactory per-
e satisfactory per-
line must be sized to ac-
formance, the gas supply
formance, the gas supply
commodate the total Btu
requirements of all the gas-
fired equipment that will be
requirements of all the gas-
requirements of all the gas-
connected to that line.
fired equipment that will be
fired equipment that will be
in no case should pipe less
than 3/4” inside diameter or
n no case should pipe less
n no case should pipe less
1” outside diameter ever be
used to connect this product.
calculate the total Btu
output of all equipment
and refer to “
output of all equipment
output of all equipment
indeX: g
output of all equipment
output of all equipment
as
supply line Runs” for
allowable run distances
upply
upply
for ¾ inch pipe. failure
to meet these minimum
for ¾ inch pipe.
for ¾ inch pipe.
requirements may reduce
performance of the grill
requirements may reduce
requirements may reduce
and any other appliances
performance of the grill
performance of the grill
running on that supply line.
and any other appliances
and any other appliances
always keep supply line
runs as short as possible.
lways keep supply line
lways keep supply line
(see indeX: “Btu output” for
specific model ouputs)
a gas shut-off valve must
be installed in an easily
accessible location by a
qualified plumber.
accessible location by a
accessible location by a
warning
Never coNNect a gas liNe directly to the grill. a pressure regulator must be
iNstalled oN all gas equipmeNt. all local codes require it aNd ly
ll Nx supplies the
correct regulator with your grill. removiNg or failiNg to iNstall the pressure
regulator caN result iN fire aNd serious persoNal iNjury aNd will void the
warraNty.