Maytag MDE17PRAYW インストール手順

1.  Check the electrical requirements. Be sure that you have the 

correct electrical supply and the recommended grounding 

method. See “Electrical Requirements.”

2.  Check that all parts are now installed. If there is an extra 

part, go back through the steps.

3.  Check that you have all of your tools.
4.  Dispose of/recycle all packaging materials.

5. Plug into a grounded outlet, or connect power.

6.  Check dryer operation. Close dryer door. (Some accumulated 

time may be on the timer on mechanical timer models due 

to factory testing.) Push START button. Using a full heat cycle 

(not the air cycle), let the dryer run for at least five minutes. 

Dryer will stop when time is used up. Make sure the dryer 

turns off.
NOTE: Dryer door must be closed for dryer to operate. 

When door is open, dryer stops, but timer continues to run. 

To restart dryer, close door and push START button.

7.  Open the dryer door. Check that the inside of the dryer is 

warm. If the burner does not ignite and you can feel no heat 

inside the dryer, shut off dryer for five minutes. Check that 

all supply valve controls are in “ON” position and that the 

electrical cord is plugged in. Repeat five-minute test.

8.  If drying time is too long, make sure that the lint screen is 

clean and that there are no obstructions to airflow in the 

dryer vent system.

9.  Restart the dryer and allow it to complete a full heat cycle 

(not air cycle) to make sure it is working properly.

2.  Grip dryer from top and rock back and forth, making sure all 

four legs are firmly on floor. Repeat, rocking dryer from side 

to side. If dryer rocks, go to Step 3 and adjust leveling legs.  

If all four legs are in firm contact with floor, go to Step 4.

HELPFUL TIP: You may want to prop up front of dryer about 4" 

(102 mm) with a wood block or similar object that will support 

weight of dryer.

4.  When dryer is level and all four legs are firmly in contact with 

the floor, use a 1" or 25 mm open-end or adjustable wrench 

to turn jam nuts counterclockwise (as viewed from above)  

on leveling legs tightly against dryer cabinet. 
HELPFUL TIP: You may want to prop dryer with wooden 

block.

3.  If dryer is not level, use a 1" or 25 mm open-end or adjustable 

wrench to turn jam nuts clockwise (as viewed from above) on 

legs until they are about 1/2" (13 mm) from the dryer cabinet. 

Then turn the leveling leg counterclockwise to lower the dryer 

or clockwise to raise the dryer. Recheck levelness of dryer and 

that all four legs are firmly in contact with the floor. Repeat as 

needed.

Jam nut