Maytag MHN30PDCWW インストール手順

Properly leveling your washer avoids excessive noise  

and vibration.

 1.  Check the levelness of the washer by placing a level on the 

top edge of the washer, first side to side, then front to back.

If the washer is against a wall, move the washer out slightly 

before tipping back. If the washer is not level, first prop the 

front with a wood block and adjust the feet as necessary;  

then, prop the back and adjust feet as necessary. Repeat  

this step until washer is level.

2.   Make sure all four feet are stable and resting on the floor.  

Then check that the washer is perfectly level (use a level).

 

3.  After the washer is level, use a  

9

⁄

16

" open-end wrench to turn 

the nuts on the feet tightly against the washer cabinet.

 IMPORTANT: All four feet must be tightened. If the nuts are 

not tight against the washer cabinet, the washer may vibrate.

 4.  The washer should not move front to back, side to side,  

or diagonally when pushed on its top edges.

5.  Slide the washer to its final location.
6.  Confirm the levelness of the washer.

1.   Check the electrical requirements. Be sure that you have the 

correct electrical supply and the recommended grounding 

method. See “Electrical Requirements.”

2.  Check that all parts are now installed. If there is an extra part, 

go back through the steps to see which step was skipped.

3.  Check that you have all of your tools.
4.  Dispose of/recycle all packaging materials.
5.  Check that the water faucets are on.
6.  Check for leaks around faucets and inlet hoses.

7.  Plug into an grounded 3 prong outlet.
8.  To test and to clean your washer, measure ½ the detergent 

manufacturer’s recommended amount of High Efficiency (HE) 

detergent for a medium-size load. Pour the detergent into  

the detergent dispenser. Select any cycle and allow the 

washer to complete one whole cycle.