Electrolux EI30GF45QS オーナーマニュアル

LOC

K

The oven door is heavy. Be careful when 
removing and lifting the door. Do not lift the oven 
door by the handle.

 

Most oven doors contain glass that can break. 
Read the following recommendations:
• Do not close the oven door until all the interior 

oven racks are fully inserted and retracted to 
the back of the oven.

• Do not hit the glass with pots, pans, or any 

other object. The oven door glass may break or 
even break at a later time unexpectedly.

• Scratching, hitting, jarring or stressing the oven 

door glass may weaken its structure causing an 
increased risk of breakage at a later time.

• You may use a glass cleaner on the outside 

of the oven door glass. Do not spray or allow 
water or the cleaner to enter or drip down into 
the oven door vents. Spray cleaner on cloth fi rst 
and then wipe the oven door clean.

• Do not use strong oven cleaners, powders or 

any harsh abrasive cleaning materials on the 
outside of the oven door or glass.

• Never clean the oven door gasket. The oven 

door gasket should always clean during the 
Self-clean cycle.

Door Hinge 

locations

with oven door 

fully open

Figure 1

Figure 2

Figure 3

Oven door

Around

Hinge

To Remove Oven Door:
1.  Open oven door completely (horizontal with 

fl oor - See Figure 1).

2.  Pull the door hinge locks on both left and 

right door hinges down from the oven frame 
completely towards the oven door (See Figure 
2). A tool such as a small fl at-blade screwdriver 
may be required.

3.  Firmly grasp both sides of oven door along the 

door sides (Do not use the oven door handle - 
See Figure 3).

4.  Close the door to the broil stop position (the 

oven door will stop into this position just before 
fully closing).

5.  With the oven door in the broil stop position, lift 

the oven door hinge arms over the roller pins 
located on each side of the oven frame (See 
Figure 4).

To Replace Oven Door:
1.  Firmly grasp both sides of oven door along the 

door sides (Do not use the oven door handle - 
See Figure 3).

2.  Holding the oven door at the same angle as 

the removal position, seat the hook of the hinge 
arm onto the roller pins located on each side of 
the oven door frame (See Fig. 4). Also, seat the 
notch of the hinge arm onto the bottom of the 
slot at the same time you seat the hook. The 
hook and notch of the hinge arms must be fully 
seated onto the roller pins and bottom of the 
slot.

3.  Fully open the oven door (horizontal with fl oor - 

See Figure 1).

4.  Push the door hinge locks up towards and into 

the oven frame on both left and right oven door 
hinges (See Figure 2) to the locked position.

5.  Close the oven door.