Friedrich PDE07R3SG インストール手順

New Construction Accessories

PDXDAA

LATERAL DUCT ADAPTER Attaches to the Friedrich PTAC/PTHP unit to direct

up to 35% of the total airflow to a second room. The unit mounted duct plenum

features a front mounted aluminum grille that has two positions to provide the

most optimal air direction. The air may be directed to either the left or the right of

the unit through the supplied 3.5 H" x 7 W" x 47" L plenum. Plenum may be cut

to length by the installer. Kit includes duct plenum, front grille, 47" duct extension,

duct discharge grille, duct end cap and all necessary mounting hardware.

PDXDEA

LATERAL DUCT EXTENSION Additional 3.5 H" x 7" W x 47" L plenum for use

with the LATERAL DUCT ADAPTER. A maximum of 3 duct extensions total may

be used. Note: Ducted airflow is reduced as duct length is increased.

PXFTA

REPLACEMENT FILTER PACK These are original equipment return air filters.

They are reusable and can be cleaned by vacuuming, washing, or blowing out,

and are sold in convenient ten-packs. (Two filters per chassis).

PXDR10

CONDENSATE DRAIN KIT Attaches to the bottom of the wall sleeve for internal

draining of condensate or to the rear wall sleeve flange for external draining.

Recommended on all units to remove excess condensate.

Packaged in quantities of ten.

RT6

DIGITAL REMOTE WALL THERMOSTAT Single stage cool, single stage heat

for PDE models or single stage cool, dual stage heat for PDH model thermostat

features high/low fan speed switch. Thermostat is hard wired and can be battery

powered or unit powered. Features backlit display and multiple configuration

modes. For use on PD-series Friedrich PTACs and Vert-I-Paks.

WRT1

DIGITAL THERMOSTAT Wireless, single stage, wall-mounted digital thermostat

with two fan speeds. Features backlit display and multiple configuration modes.

PDXRTA

REMOTE THERMOSTAT ESCUTCHEON KIT This kit contains ten escutcheons

that can be placed over the factory control buttons when a remote wall mounted

thermostat is used. The escutcheon directs the guest to the wall thermostat for

operation and retains the LED window to display error codes and diagnostic

information.

FRIEDRICHLINK® ENERGY MANAGEMENT THERMOSTAT Integrated oc-

cupancy sensor uses a combination of motion and thermal sensing technologies

for accurate occupancy detection. Reliable occupancy detection allows saving en-

ergy when rooms are unoccupied. Energy saving presets eliminate the guesswork

and make it easy to adjust the energy saving settings.

EMWRT1

Wireless thermostat with occupancy sensor.

EMRT1

Wired thermostat with occupancy sensor.