Maytag MVWB855DW インストール手順

Run water for a few seconds through hoses into a laundry tub, 

drainpipe, or bucket to avoid clogs. Water should run until clear.
Make note of which hose is connected to hot water to help in 

attaching hoses to washer correctly.

Attach hot water hose to hot water inlet valve marked with a 

red ring. Screw coupling by hand until it is snug. Use pliers to 

tighten couplings an additional two-thirds turn. Repeat with 

cold water inlet valve.

IMPORTANT: To reduce risk of hose failure, replace the hoses 

every 5 years. Record hose installation or replacement dates 

for future reference.

n

  Periodically inspect and replace hoses if bulges, kinks, cuts, 

wear, or leaks are found.

Turn on water faucets to check for leaks. A small amount of 

water may enter washer. It will drain later.

Washer must be connected to water faucets with new inlet 

hoses with flat washers (not provided). Do not use old hoses.
NOTE: Both hoses must be attached and have water flowing 

to inlet valves. If you are only connecting to a cold water  

faucet, you must use a Y-adapter (not provided).

Attach hose to hot water faucet. Screw on coupling by hand 

until it is seated on washer. Use pliers to tighten couplings an 

additional two-thirds turn. Repeat this step with second hose 

for cold water faucet.

IMPORTANT: Do not overtighten or use tape or sealants on 

valve when attaching to faucets or washer. Damage can result.

For floor drain installations, you will need to remove the drain 

hose form from the end of the drain hose. You may need  

additional parts with separate directions. See “Tools and Parts”.