Frigidaire FFLG4033QT インストール手順

5

Hot and cold water faucets MUST be installed within 42 

inches (107 cm) of your washer’s water inlet. The faucets 

MUST be 3/4 inch (1.9 cm) with threading for laundry 

hose connection. Water pressure MUST be between 

10 psi (0.69 bars) and 120 psi (8.27 bars). Pressure 

difference between hot and cold cannot be more than 10 

psi. Your water department can advise you of your water 

pressure.

Uncoated copper tubing will corrode when subjected 

to natural gas, causing gas leaks. Use ONLY black iron, 

stainless steel, or plastic-coated brass piping for gas 

supply.

CIRCUIT -  Individual, properly polarized and grounded 

15 amp. branch circuit fused with 15 amp. time delay 

fuse or circuit breaker.

POWER SUPPLY - 2-wire, with ground, 120 volt, single 

phase, 60 Hz, Alternating Current. 

POWER SUPPLY CORD - The dryer is equipped with a 120 

volt 3-wire power cord. 

GROUNDING CONNECTION - See “Grounding 

requirements” in Electrical Installation section. 

Grounding type

Grounding type
wa

wall receptacl

ll receptacle

Po

Power cord with

wer cord with

3-prong 

3-prong  gr

grounded plug

ounded plug

1  Installation MUST conform with local codes, or in 

the absence of local codes, with the National Fuel 

Gas Code, ANSI Z223.1 (latest edition). 

2  The gas supply line should be 1/2 inch (1.27 cm) 

pipe. 

3  If codes allow, fl exible metal tubing may be used 

to connect your dryer to the gas supply line. The 

tubing MUST be constructed of stainless steel or 

plastic-coated brass.

  4  The gas supply line MUST have an individual 

shutoff valve installed in accordance with the 

B149.1, Natural Gas and Propane Installation Code.

  5  A 1/8 inch (0.32 cm) N.P.T. plugged tapping, 

accessible for test gauge connection, MUST be 

installed immediately upstream of the gas supply 

connection to the dryer.

  6  The dryer MUST be disconnected from the gas 

supply piping system during any pressure testing 

of the gas supply piping system at test pressures in 

excess of 1/2 psig (3.45 kPa).

  7  The dryer MUST be isolated from the gas supply 

piping system during any pressure testing of the 

gas supply piping system at test pressures equal to 

or less than 1/2 psig (3.45 kPa).

  8  Connections for the gas supply must comply with 

the Standard for Connectors for Gas Appliances, 

ANSI Z21.24.

Washers connected to water supplies with lower inlet 

pressure will experience longer fi lling times and may 

not complete cycles as quickly.