Intel AUGSBURG S775 I915G MATX 10PK KD915GAGLKPAK10 ユーザーズマニュアル
製品コード
KD915GAGLKPAK10
Technical Reference
2.9 Jumper Block
CAUTION
Do not move the jumper with the power on. Always turn off the power and unplug the power cord
from the computer before changing a jumper setting. Otherwise, the board could be damaged.
from the computer before changing a jumper setting. Otherwise, the board could be damaged.
Figure 23 shows the location of the jumper block on the D915GAV board. (The jumper is in the
same location on the D915GAG board.) The jumper block determines the BIOS Setup program’s
mode. Table 37 describes the jumper settings for the three modes: normal, configure, and recovery.
When the jumper is set to configure mode and the computer is powered-up, the BIOS compares the
processor version and the microcode version in the BIOS and reports if the two match.
same location on the D915GAG board.) The jumper block determines the BIOS Setup program’s
mode. Table 37 describes the jumper settings for the three modes: normal, configure, and recovery.
When the jumper is set to configure mode and the computer is powered-up, the BIOS compares the
processor version and the microcode version in the BIOS and reports if the two match.
OM16672
3
1
J8J4
Figure 23. Location of the Jumper Block
Table 37. BIOS Setup Configuration Jumper Settings
Function/Mode Jumper
Setting Configuration
Normal
1-2
1
3
The BIOS uses current configuration information and
passwords for booting.
passwords for booting.
Configure
2-3
1
3
After the POST runs, Setup runs automatically. The
maintenance menu is displayed.
maintenance menu is displayed.
Recovery
None
1
3
The BIOS attempts to recover the BIOS configuration. A
recovery diskette is required.
recovery diskette is required.
75