Intel AUGSBURG S775 I915G MATX 10PK KD915GAGLKPAK10 ユーザーズマニュアル

製品コード

KD915GAGLKPAK10

Intel Desktop Board D915GAV/D915GAG Technical Product Specification

2.11.3 Fan Connector Current Capability

CAUTION

The processor fan must be connected to the processor fan connector, not to a chassis fan
connector. Connecting the processor fan to a chassis fan connector may result in onboard
component damage that will halt fan operation.

Table 39 lists the current capability of the fan connectors.

Table 39. Fan Connector Current Capability

Fan Connector

Maximum Available Current

Processor fan

1000 mA

Front chassis fan

600 mA

Rear chassis fan

600 mA

Rear chassis fan 2

600 mA

✏

NOTE

The rear chassis fan 2 is available only on the D915GAV board. It is not available on the
D915GAG board.

2.11.4 Power Supply Considerations

CAUTION

The +5 V standby line for the power supply must be capable of providing adequate +5 V standby
current. Failure to do so can damage the power supply. The total amount of standby current
required depends on the wake devices supported and manufacturing options.

System integrators should refer to the power usage values listed in Table 38 when selecting a power
supply for use with the board.

Additional power required will depend on configurations chosen by the integrator.

The power supply must comply with the following recommendations found in the indicated
sections of the ATX form factor specification.
•  The potential relation between 3.3 VDC and +5 VDC power rails (Section 4.2)
•  The current capability of the +5 VSB line (Section 4.2.1.2)
•  All timing parameters (Section 4.2.1.3)
•  All voltage tolerances (Section 4.2.2)