Intel AUGSBURG S775 I915G MATX 10PK KD915GAGLKPAK10 ユーザーズマニュアル

4.1

 

BIOS Error Messages .................................................................................................. 97

 

4.2

 

Port 80h POST Codes ................................................................................................. 99

 

4.3

 

Bus Initialization Checkpoints .................................................................................... 103

 

4.4

 

Speaker ..................................................................................................................... 104

 

4.5

 

BIOS Beep Codes...................................................................................................... 104

 

Table 49 lists the error messages and provides a brief description of each. 

GA20 Error 

An error occurred with Gate A20 when switching to protected 
mode during the memory test.  

Pri Master HDD Error  
Pri Slave HDD Error 

Could not read sector from corresponding drive. 

Pri Master Drive - ATAPI Incompatible 
Pri Slave Drive - ATAPI Incompatible 

Corresponding drive in not an ATAPI device.  Run Setup to make 
sure device is selected correctly. 

A:  Drive Error 

No response from diskette drive. 

Cache Memory Bad 

An error occurred when testing L2 cache.  Cache memory may be 
bad. 

CMOS Battery Low 

The battery may be losing power.  Replace the battery soon. 

CMOS Display Type Wrong 

The display type is different than what has been stored in CMOS.  
Check Setup to make sure type is correct. 

CMOS Checksum Bad 

The CMOS checksum is incorrect.  CMOS memory may have 
been corrupted.  Run Setup to reset values. 

CMOS Settings Wrong 

CMOS values are not the same as the last boot.  These values 
have either been corrupted or the battery has failed. 

CMOS Date/Time Not Set 

The time and/or date values stored in CMOS are invalid.  Run 
Setup to set correct values. 

DMA Error 

Error during read/write test of DMA controller. 

FDC Failure 

Error occurred trying to access diskette drive controller. 

HDC Failure 

Error occurred trying to access hard disk controller. 

Checking NVRAM..... 

NVRAM is being checked to see if it is valid. 

continued 

 97