Whirlpool WTW7000DW 使用とお手入れ

Troubleshooting

Incorrect dispenser 

operation

Clogged dispensers or laundry  

products dispensing too soon.

Do not overfill dispenser. Overfilling causes immediate dispensing.
Load dispensers before starting a cycle.
It is normal for small amounts of water to be remain in dispenser 

at the end of the cycle.
Fabric softener thickens as it gets older. If there becomes an 

increase of fabric softener in the dispenser after a cycle, then 

check the age of the fabric softener and replace if needed.
Homes with low water pressure may result in residual powder  

in the dispenser. To avoid, select a warmer wash temperature  

if possible, depending on your load.

Liquid chlorine bleach not used in 

dispenser.

Use only liquid chlorine bleach in the bleach dispenser.

Single-dose laundry 

packet not dissolving

Adding laundry packet incorrectly.

Be sure laundry packet is added to washer basket before adding 

clothes. Follow the manufacturer’s instructions to avoid damage 

to your items.

F#E# code (F-type error 

code) appears in display

System error code.

Touch POWER to clear the code and exit cycle. Then touch 

POWER, select cycle, and then touch and hold START/PAUSE 

to start washer. If code appears again, call for service.

F8E1 or LF (too long to 

fill) appears in display

Washer taking too long to fill. Drain 

extends more than 4.5" (114 mm) into 

standpipe.

Check plumbing for correct drain hose installation. Use drain 

hose form and attach securely to drainpipe or tub. Do not tape 

over drain opening. See Installation Instructions.
Make sure water supply line is turned on.

F9E1, drn, dr (drain 

pump system problem 

- long drain) appears in 

display

Washer taking too long to drain  

water. Drain extends more than  

4.5" (114 mm) into standpipe.

Check plumbing for correct drain hose installation. Use drain 

hose form and attach securely to drainpipe or tub. Do not tape 

over drain opening. 
Lower drain hose if the end is higher than 96" (2.4 m) above 

the floor. Remove any clogs from drain hose. See Installation 

Instructions.

F8E6 (Lid opened) 

appears in display

Washer lid left open.

Close the lid and touch Power to clear the display. If the lid is left 

open for more than 10 minutes, the cycle will reset and water in 

the washer will drain.

F1E1 ACU (Appliance 

control fault)

Internal ACU failure.

Call for service.

F2E5 UI/ACU mismatch

Wrong ACU or UI has been installed.

Call for service.

F3E1 Water level sensing 

failure

Pressure sensor on ACU failure.

Call for service.

F5E2 Lid lock will not 

lock or lid lock failure

An item in the load maybe keeping 

the lid from locking.

Check for items directly under the lid.

F5E3 Lid cannot unlock

Objects on washer lid prevent it from 

unlocking.

Remove objects, such as baskets of laundry, from top of washer.

F6E2 or F6E3 

Communication Error:  

UI cannot communicate

ACU or UI synchronization error.

Remove power from the washer. Let washer set for 5 minutes for 

the washer to completely power down. Apply power to washer 

and check for error codes. If the error code persists call for 

service.

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help - 

In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.