Perlick HC24TB31L2 インストール手順

perlick.com

PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT

4. If installing a two or three faucet system, a CO2

manifold will need to be installed. Locate the red

CO2 lines, CO2 manifold and a #10 x 1/2” sheet metal

screw. Slide one end of each hose onto the barbed

fittings on the manifold and clamp. On the left rear

side wall of the beer compartment there is a double

row of screws which run vertically. Remove one of

the two top screws and discard. Insert the sheet

metal screw through the manifold and into the hole

vacated previously.

5. On a single beer system, locate the red CO2 hose.

Slide one end onto the barbed fitting of the regulator

assembly and clamp. On systems with two or three

beers, locate the CO2 line that comes off the backside

of the manifold assembly. Slide the hose onto the

barbed fitting of the regulator assembly and clamp.

For detailed information on connecting the regulator

to the CO2 cylinder, see page 8.

6. Locate the keg coupler(s). Slide one of the red CO2

lines onto the larger barbed fitting of coupler and

clamp. Locate one of the black beer lines and slide

onto the smaller barbed fitting of the coupler and

clamp. Repeat for additional couplers.