Viking VGR7364GBU インストール手順
27
Only authorized replacement parts may be used in performing service on the appliance.
All servicing should be referred to a qualified technician.
Contact Viking Range, LLC, 1-888-(845-4641), for the nearest service parts distributor in your
area or write to:
VIKING RANGE, LLC
PREFERRED SERVICE
111 Front Street
Greenwood, Mississippi 38930 USA
The serial number and model number for your appliance can be found
by opening the door and looking under the control panel. A duplicate
label is located on the back side of the range.
by opening the door and looking under the control panel. A duplicate
label is located on the back side of the range.
Record the following information indicated below. You will need it if
service is ever required.
service is ever required.
Model number
____________________________________________________________________________________
Serial number
_____________________________________________________________________________________
Date of purchase
__________________________________________________________________________________
Date installed
______________________________________________________________________________________
Dealer's name
_____________________________________________________________________________________
Address
___________________________________________________________________________________________
These installation instructions should remain with the unit
for future reference.
26
Performance Checklist
A qualified installer should carry out the
following checks:
• Check top burner ignition. See drawing
for proper flame height on HI. The low
flame should light at every port.
• Check oven bake function—bake burner on
full power.
• Check convection bake function—bake
burner at full power with the convection
fan on.
• Check broil function—broil burner at full
power.
• Check convection broil function—broil
burner at full power with convection fan on.
• Check convection fan function—convection
fan comes on when switch is turned on.
• All stainless steel body parts should be
wiped with hot, soapy water and with a
liquid cleaner designed for this material.
If buildup occurs, DO NOT use steel wool,
abrasive cloths, cleansers, or powders!
If it is necessary to scrape stainless steel
to remove encrusted materials, soak with
hot, wet cloths to loosen the material, then
use a wooden or nylon scraper. DO NOT
use a metal knife, spatula, or any other
material tool to scrape stainless steel!
Scratches are almost impossible to
remove.
Service & Registration
Final Preparation