Zephyr AK8000ASES 使用とお手入れ
T
roubleshooting
14
www.zephyronline.com
TROUBLESHOOTING PROCEDURES FOR TWISTER
Issue
Cause
What to do
After installation,
the unit doesn’t
work.
the unit doesn’t
work.
1. The power source is not turned ON.
1. Make sure the circuit breaker and the unit’s
power is ON.
2. The power line and the cable locking connector
is not connecting properly.
2. Check the power connection with the unit is
connected properly.
3. The switch wirings are disconnected.
3. Make sure the wirings at the switch are
connected properly.
5. The switch is defective.
5. Change the switch.
Light works, but
blower is not
turning.
blower is not
turning.
1. The blower cable is unpluged.
1. Connect the blower cable.
2. The blower is defective, possible seized.
2. Change the blower.
3. The thermally protected system detects if the
blower is too hot to operate and shuts the blower
down.
down.
3. The blower will function properly after the
thermally protected system cool down.
4. Damaged capacitor.
4. Change the capacitor.
The unit is
vibrating.
vibrating.
1. The blower is not secure in place.
1. Tighten the blower in place.
2. Damaged blower wheel.
2. Change the blower.
3. The hood is not secured in place.
3. Check the installation of the hood.
The blower is
working, but the
lights are not.
working, but the
lights are not.
1. Light socket connector is unpluged.
1. Connect the light socket connector.
2. Defective bulb.
2. Change the bulb.
3. The light bulb is loose.
3. Tighten the light bulb.
The hood is
not venting out
properly.
not venting out
properly.
1. The hood might be hanging to high from the
cook top.
1. Adjust the distance between the cook top and
the bottom of the hood within 26” to 36” range.
2. The wind from the opened windows or opened
doors in the surrounding area are affecting the
ventilation of the hood.
ventilation of the hood.
2. Close all the windows and doors to eliminate
the outside wind fl ow.
3. Blocking in the duct opening or duct work.
3. Remove all the blocking from the duct work or
duct opening.
4. The direction of duct opening is against the wind.
4. Adjust the duct opening direction.
5. Using the wrong size of ducting.
5. Change the ducting to at least 6” or higher.
Metal fi lter is
vibrating.
vibrating.
1. Metal fi lter is loose.
1. Change the metal fi lter.
2. Spring clip is broken.
2. Change the spring clip.