Verona VECTEM304 使用とお手入れ

10

This touch control works using optical light sensing 

technology.  When  first  connecting  electrically  or 

after a power failure, any direct strong light over the 

sensor area may affect the touch control functionality. 

When powering on the unit make sure that no strong 

light is shining direct over the touch control zone, 

it can compromise the start-up sensor calibration 

resulting in an unresponsive touch control.

When the cooktop is connected to the electrical voltage 

supply all lights and digits turn on to indicate a proper 

activation. This operation will be completed after few 

seconds, the control turns off automatically. Now the 

cooktop is ready for operations.

Eventually hold the [LOCK] key in case the commands 

are locked (see that the lock led is on and turns off after 

a few seconds).
Touch the main [ON/OFF] key in order to make each 

single zone available for selection. 
All the displays show power level “0”, if no actions are 

performed the control shuts down again after about 10 

seconds.

Touch the proper [ON] key (ref.2) in order to select the 

desired zone: the HOT SURFACE (ref.3) indication 

starts flashing, waiting for a user input.

Touch the slide bar to set the power level (levels 0 to 

9 are available), moving the finger along it or directly 

touching the desired value. If your cooktop model has 

no slide bar.

The display (ref.4) and the “Peacock Tail” (ref.6) show 

the power level, updated in real time.
After a 5 seconds time-out the value is accepted, the 

HOT  SURFACE  led  (ref.3)  stops  flashing  and  gets 

steady. The “Peacock Tail” disappears after some 

seconds more.
Touch [ON] key to confirm the value before the time-out 

expires.
The following picture represents the Full Power Scale 

whereas the control uses all the available power range, 

from 0% up to the 100% corresponding to level 9. 
Level 4 corresponds to 15% of the available power.

Once a cooking zone has been selected, touch the 

[LOW TEMP] key (ref.8) in order to enable the Low 

Power Scale (ref.9) then set the power level in the 

usual way.