Frigidaire FFTA1233Q1 インストール手順

1. Remove existing rear grille as shown on Page 3 of this manual and 

replace with provided louvered rear panel. Install as shown here.

80º

50º

50º

Rear Louvers

80º

Top View

2.  Place (2) 1" x 1   " x 14" seals against each side.

1

2

10. Install the divider into the slots of the foam blocks. You may need to 
      trim the length to size.

11. Repeat steps 8-10 for the other vertical shown portion of the grille as 
      shown in the picture.

8. Attach 1" x    " x 14" long seal over the solid vertical portion of the rear
     grille.

3

4

9. Attach (2) 4   " x 3   " x 1   " foam blocks with the slot overlapping the
     seal above.

3

4

3

4

3

4

12. Attach (2) 1" x 1   " x 14" seals along the sides of the sleeve again 
      making sure all seals are flush.

1

2

14. Center unit & gently slide unit into sleeve.

15. Before sliding all-the-way back, remove 2nd screw from front on left
      side of unit.

16. Remove the plastic washer from the screw.

18. Slide the unit completely to the rear to ensure a good seal, making
      sure the ground wire does not become tangled.

19. Seal & Frame the unit as described on the last page of these instructions.

13. Cut the 1" x 1   " x 25" seal to fit the top of the sleeve. The pieces must 
      be fitted flush to the edge of the divider.

1

2

4.  If position is okay, remove unit and Proceed to the next step.If not go 
     to step 8.

3.  Gently slide unit in and check if amount extending from the sleeve is 
     sufficient once the trim frame is attached.

12

5. Attach (1) 1" x 1   " x 15" seal to the left and right sides of the sleeve.

1

2

6.  Cut (1) 1" x 1   " x 25" long seal to 14" long and attach it vertically to
     the rear grill 3.5" from the left side. Repeat and attach 3" from the 
     right side.

1

2

7. Attach (1) 1" x 1   " x 25" long seal in the center at the top of the 
     sleeve. Remove the backing paper and press into position. Proceed
     to step 14.

1

2

NOTE: You may need to drill holes in flange of existing sleeve to match
new rear grille 

20. If you have difficulty with mounting the grill to the sleeve, follow the
      instructions for direct mounting on Page 13.

17.

Screw and attach the other end of the ground wire from sleeve to the

      unit as shown in picture. Make sure that the toothed washer is against
      the cabinet.

4.5"

4"

4.5"

4"

4.5"

4"