Zephyr AK7036BS マニュアル

www.zephyronline.com

1.  Position the air diverter box under cabinet. Mark the (4) key-

holes for the 3/16” x 1/2” screws and electrical knock out 

opening with a pencil. Remove air diverter box and install the 

(4) 3/16” x 1/2” screws. Do not tighten screws all the way. 

Drill out the electrical knock-out opening.

Note: Reinforce cabinet with 1” x 2” wood strips if additional 

strengthening is required or if cabinets are framed.

2.  Lift air diverter box and align the holes on top of the air 

diverter box with the screws recently installed. Slide the air 

diverter box towards the wall to temporarily lock in place. 

Hand tighten the (4) screws. (Fig. A)

3.   Lift Tempest I range hood and align the key-holes on top of 

the hood with the screws protruding from the bottom of the 

air diverter box. Slide hood towards wall to temporarily lock 

in place. Hand tighten the (4) screws. (Fig. A)

Note: Electrical wiring will pass through the cabinet bottom, 

air diverter box and connect to the hood wiring. See Tempest 

I instruction manual for more details.

4.  Further secure the hood to the air diverter box by fastening 

M4 x 8 screws to each of the (8) holes on the bottom of the 

air diverter box. You can gain access to the screw holes from 

within the hood. The holes on top of the Tempest I will align 

with the holes on the bottom of the air diverter box. (Fig. B)

(8) M4 x 8 screws go here

Fig. A

Fig. B