Zephyr AK7036BS 入門ガイド

www.zephyronline.com

Clean the remote control using non abrasive detergents

Follow instructions below for replacing battery.                                        
8VLQJDVPDOOÀDWKHDGVFUHZGULYHUUDLVHWKHFRYHURIWKHEDWWHU\
GRRUALQRUGHUWRDFFHVVWKHEDWWHU\FRPSDUWPHQW),*

Remove the battery and replace with battery type A23 12V.                                     
Negative end of battery should face the spring inside the remote.

Re-install battery door and recycle old battery.

The RF remote control is equipped with a magnet on the back for easy 
storage. The remote may be placed on any magnetic surface such as a 
refrigerator or the Zephyr remote holder, FIG. 1.  The remote holder can 
be inserted into a standard electrical outlet for easy storage. Note: The 
remote holder does not charge the RF remote.  

Maximum remote control communication distance is 15 feet from the hood. 

To create a unique link between your hood and remote control please follow these steps:

1. With hood off, press and hold the “lights” button on the hood until the letter “F” shows on the display screen. 

                 

 2. Press the “lights” button on the remote, the lights on the hood will turn on and synchronization is complete.                            

                          

FIG. 1

FIG. 2

Press        to power on blower and cycle through all six blower speeds. 

By pressing      , the blowers will power on at the last speed setting.  Press 
again and the entire hood will power off, including lights.

Switch lights On by pressing       once, again to dim and again to switch Off.

Blower On/

Speed Selection

1

1

2

3

4

Blower On/
Power Off

2

5 Min Delay Off

3

Lights On/Dim/Off

4

By pressing      , the blower and lights will enter Delay Off mode.  A dot will 
appear in the lower right corner of the hood display        indicating the function 
is on.  The blower will change to speed 1 and shut down after 5 minutes.

-

+

FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compli-
ance could void the user’s authority to operate this equipment.  (Example - use only shielded interface cables when connecting to computer 
or peripheral device.  This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions.  (1) This device 
may not  cause harmful interference, and (2) This device must accept any interference received, including interference that may cause 
undesired operation.