Zephyr ZANM90BS オーナーマニュアル

1.  Measure from range top to desired hood bottom and 

mark line A.  (26” minimum from range top) .

2.  Plum and mark center line.

3.  Mark hood height line B. (18-7/16” from line A)

4.  Mark mounting spread from C/L. (8-7/8” on line B) 

5.  Fasten (2) M4 x 1-1/2” screws into studs on line B but 

do not tighten all the way.  Note: Wood blocking may 
need to be added behind the drywall if no studs are 
present.  Wall anchors may also be used but check 
local codes for compliance. Failure to use suitable 
wall anchors and screws to hold the weight of the 
hood could result in personal injury or damage to 
cooking surface or counter.

6.  Remove the (2) aluminum mesh fi lters.

7.  Hang hood onto the mounting screws and hand tighten 

each screw. (Fig A1) Secure a third M4 x 1-1/2” screw 
through inside of hood into wall for extra support. (Fig 
A2)

8.  Center and attach duct cover mounting bracket to wall 

just below the ceiling or soffi t using (2) M4 x 1” screws.

9.   Install electrical and duct work.  Seal duct work with 

aluminum duct tape.

10. Power up hood and check for leaks around duct tape.

11. Place telescopic duct covers onto hood and extend 

inner (top) duct cover upwards and secure to duct cover 
bracket using (2) M4 x 8 screws. Reinstall mesh fi lters.

   * If using hood in recirculating mode you must secure the 

air diverter plate onto wall before installing duct work 
and duct covers.  You will also need to install charcoal 
fi lters and brackets. Turn to page 10 for more details.

18-

7/16

”

Brackets are 

pre-installed

Fig. A1

Fig. A2

26” min

8-

7/8

”

A

B

Cable Lock

A cable locking connector (not supplied) might 
be required by local codes.  Check with local 
requirements and codes, purchase and install 
appropriate connector if necessary.