Amana NTW4701BQ オーナーマニュアル

To reinstall washer after non-use, vacation, winter storage,  

or moving:

1.  Refer to “Installation Instructions” to locate, level, and  

connect washer.

2.  Before using again, run washer through the following   

recommended procedure:

To use washer again:
1.  Flush water pipes and hoses. Reconnect water inlet hoses. 

Turn on both water faucets.

2.  Plug in washer or reconnect power. 
3.  Run washer through Casual Regular cycle to clean washer 

and remove antifreeze, if used. Use half the manufacturer’s  

recommended amount of detergent for a medium-size load.

Vibration or Off-Balance
Check the following for  

proper installation or see 

“Using Your Washer” 

section

Feet may not be in contact with the 

floor and locked.

Front and rear feet must be in firm contact with floor, and washer 

must be level to operate properly. 

Washer may not be level.

Check floor for flexing or sagging. If flooring is uneven, a 3/4"  

(19 mm) piece of plywood under your washer will reduce sound.
See “Level the Washer” in Installation Instructions.

Load could be unbalanced.

Load dry garments in loose heaps evenly around basket wall. 

Adding wet garments to washer or adding more water to basket 

could unbalance washer.
Wash smaller loads to reduce imbalance.
Do not tightly pack. Avoid washing single garments.
Use the Normal Regular cycle and select Large Load Size for 

oversized, non-absorbent garments such as comforters or  

poly-filled jackets.
See “Cycle Guide” and “Using Your Washer.”

Noises
Clicking or  

metallic noises

Objects caught in washer  

drain system.

Empty pockets before washing. Loose items such as coins 

could fall between basket and tub or may block pump. It may be 

necessary to call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps, 

buckles, or zippers touch against the basket. 

Gurgling or humming

Washer may be draining water.

It is normal to hear the pump making a continuous humming 

sound with periodic gurgling or surging as final amounts of water 

are removed during the Drain/Spin cycles.

Humming

Load sensing may be occuring.

You may hear the hum of the sensing spins after you have 

started the washer. This is normal.

First try the solutions suggested here or visit our website at www.amana.custhelp.com - 

In Canada www.amanacanada.ca for assistance and to possibly avoid a service call