Gaggenau VG424210CA インストール手順
12
For flush mounting:
Installation Procedure
Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
power supply, make sure all controls are in the
OFF position.
1
Hold the holding plate against the front panel
from the rear. Insert the control knobs in the
holes from the front and screw it down them from
the rear with the nuts. Pay attention to correct
assignment of the control knobs (see figure).
from the rear. Insert the control knobs in the
holes from the front and screw it down them from
the rear with the nuts. Pay attention to correct
assignment of the control knobs (see figure).
2
Evenly insert the unit in the cut-out. Press the unit
firmly into the cut-out from above.
firmly into the cut-out from above.
Note: The unit must sit firmly in the cut-out and
must not move (e.g. during cleaning). If
necessary, secure strips at the sides in the cut-
out if the cut-out width is at the top tolerance
limit.
must not move (e.g. during cleaning). If
necessary, secure strips at the sides in the cut-
out if the cut-out width is at the top tolerance
limit.
3
Turn the control knobs and the gas valves to the
zero position. Assemble the spindles between the
control knobs and the gas valves. Slide the rear
parts fully over the gas valve shafts. Fix the
spindles in place with the locking screws.
zero position. Assemble the spindles between the
control knobs and the gas valves. Slide the rear
parts fully over the gas valve shafts. Fix the
spindles in place with the locking screws.
4
Connect the appliance to the mains and gas and
check that it is working. If the appliance switches
off, there may be air in the gas pipe. turn the
control knob to 0 and ignite again. Repeat the
operation until the appliance ignites.
check that it is working. If the appliance switches
off, there may be air in the gas pipe. turn the
control knob to 0 and ignite again. Repeat the
operation until the appliance ignites.
PP
PLQ
PD[
D
E
F