Electrolux EIMED60LT インストール手順

Remove the shipping cap from gas pipe at the 

1. 

rear of the dryer.

The supply line must be equipped with an 
approved manual shutoff valve. This valve 
should be located in the same room as the dryer 
and should be in a location that allows ease of 
opening and closing. Do not block access to the 
gas shutoff valve.

Connect a 1/2 inch (1.27 cm) I.D. semi-rigid or 

2. 

approved pipe from gas supply line to the 3/8 
inch (0.96 cm) pipe located on the back of the 
dryer. Use a 1/2 inch to 3/8 inch (1.27 cm to 
0.96 cm) reducer for the connection. Apply an 
approved thread sealer that is resistant to the 
corrosive action of liquefi ed gases on all pipe 
connections.

Open the shutoff valve in the gas supply line to 

3. 

allow gas to fl ow through the pipe. Wait a few 
minutes for gas to move through the gas line.

DO NOT connect the dryer to L.P. gas service 
without converting the gas valve. An L.P. 
conversion kit must be installed by a qualifi ed 
gas technician.

EXPLOSION HAZARD

NEVER test for gas leaks with an open fl ame.

All connections must be wrench-tightened

Flare

Union

Flare

Union

GAS FLOW

Manual

Shutoff

Valve

Closed

Open

Flexible

Connector

Inlet Pipe on

Back of Dryer

e

l

p

p

i

N

Check for gas system leaks with a manometer. 

4. 

If a manometer is not available, test all 
connections by brushing on a soapy water 
solution.