Electrolux E23BC68JPS オーナーマニュアル

 

1  Open freezer drawer.

 

2  Remove drawer screws on right and left sides 

(two (2) screws on each side).

 

3  Lift drawer up and out to remove.

 

1  With lower slides pulled out, hang drawer onto 

slide brackets ensuring pins on each side are 
fully inserted into slots on each side.

 

6  Tighten four (4) drawer screws.

 

7  Recheck gasket seal.

 

8  Install the toe grille by fitting into place.

 

2  Reinstall four (4) drawer screws (two (2) per 

side), tighten down, and close drawer (C).

Pull Drawer Out

From Both Sides

Grab Drawer

At Center

Then

Push Against

Freezer Drawer

Fully Extend  

Assembly

 

Drawer Slides

Pin

Slot

Cabinet

Drawer

Install Screws

(2) Each Side

 

3  Check gasket seal around top, bottom, and sides 

of freezer drawer.

 

4  If gasket is not sealed, open drawer and slightly 

loosen four (4) drawer screws (two (2) on each 
side) to allow drawer to rotate.

 

5  Close drawer and recheck the seal on the gasket 

(A). Open the drawer grabbing by the sides in the
center (B).  Be careful not to rotate the drawer.

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Do Not Remove

Other Screws

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Do Not Remove

Other Screws