Summit FF63BDTPUBADA オーナーマニュアル
14
For the model SCR312LPUB series
1. Remove the door gasket on the side you wish to
1. Remove the door gasket on the side you wish to
install the handle - you can see two designated
holes for handle installation. The gasket is easily
displaced by hand; no tools are necessary.
holes for handle installation. The gasket is easily
displaced by hand; no tools are necessary.
, install the handle as follows:
2. Install the handle tightly as shown with two screws,
lock washers and flat washers provided. (DO NOT
over tighten as this will cause damage to the handle
and stainless steel door frame).
over tighten as this will cause damage to the handle
and stainless steel door frame).
3. Replace the door gasket to its original position.
The model FF29KDTPUB series
does not have a removable handle.
Operating Your Pub Cellar
Digital Thermostat
The temperature inside your appliance is controlled by a digital thermostat located at the
front of the unit. Normally, the LED display shows the current temperature inside the
unit.
front of the unit. Normally, the LED display shows the current temperature inside the
unit.
:
The preset temperature range of the thermostat is 41 to 65
ºF (5 to18
°C)
, and the
operating temperature is factory-set at 45ºF (
7°C)
.
If you find that it is necessary to
change the temperature setting (Set Point) for your appliance, refer to the appropriate
instructions below.
instructions below.
Series models FF7LBLPUB, FF29KDTPUB, FF63BDTPUB and SCR600BLPUB
The front panel of the thermostat for these models is illustrated here:
:
To see the SET POINT:
Push and immediately release the SET key. The display will show the Set Point
value. Wait 5 seconds and the interior temperature will display again.
To change the SET POINT:
Push and immediately release the SET key. The display will show the Set Point
value. Wait 5 seconds and the interior temperature will display again.
To change the SET POINT:
1.
Push and hold the SET key for more than 3 seconds to change the Set Point
value. The value of the Set Point will be displayed.
value. The value of the Set Point will be displayed.
2.
Push the UP or DOWN arrow to the desired setting. The new setting will be
memorized after 15 seconds, provided no other keys are pushed.
memorized after 15 seconds, provided no other keys are pushed.
Handle
Door Frame
Gasket
Screw
Lock Washer
Flat Washer