Zephyr CCAE48ASX マニュアル

www.zephyronline.com

$PLQLPXPRI´URXQGRU´[´UHFWDQJXODU
duct work must be used to maintain maximum air 
ÀRZHI¿FLHQF\ZLWKWKHFIPLQWHUQDOEORZHU
$PLQLPXPRI´WR´URXQGGXFWZRUNPXVWEH
used with the 1000 cfm external blower.

Always use rigid type metal ducts only. Flexible 
GXFWVFRXOGUHVWULFWDLUÀRZE\XSWR

Use calculation (on page 5) to compute total 
available duct run when using elbows, transitions 
and caps.

ALWAYS, when possible, reduce the number or 
transitions and turns. If long duct run is required, 
LQFUHDVHGXFWVL]HIURP´WRRU´,IDUHGXFHULV
used, install a long reducer instead of a pancake 
reducer. Reduce duct size as far away from 
opening as possible.

If turns or transitions are required; install as far 
away from opening and as far apart, between 2, 
as possible.

Minimum mount height between range top and 
KRRGERWWRPVKRXOGEHQROHVVWKDQ´

Maximum mount height should be no higher than 
´

It is important to install the hood at the proper 
mounting height. Hoods mounted too low could 
UHVXOWLQKHDWGDPDJHDQG¿UHKD]DUGZKLOHKRRGV
mounted too high will be hard to reach and will 
ORVHLWVSHUIRUPDQFHDQGHI¿FLHQF\

If available, also refer to range manufacturer’s 
height clearance requirements and recommended 
hood mounting height above range.

Vertical:
´URXQGPLQLPXPLQWHUQDOEORZHU
´WR´URXQGPLQLPXPH[WHUQDOEORZHU

Horizontal:
´[´PLQLPXPLQWHUQDOEORZHU
No horizontal option available for external blower

10-23/64"

36"

96"

Min 24"-Max 32"