Zephyr ZGEE30AS オーナーマニュアル

www.zephyronline.com

10) Place 6” round ducting over blower collar and secure  

      with aluminum duct tape.  If using hood in ductless   

      recirculating mode turn to page 13.

      Install electrical wiring.  Note: A cable lock (not        

      included) may be required by local codes.  Check         

      with local requirements and codes, purchase and install  

      appropriate connector if necessary.

      Make sure no packing material is inside hood.  Power    

      up hood check for leaks around duct tape and verify all  

      functions.

11) Secure (2) 1” wood screws (A) into the screw holes on 

the left and right sides of the f lter opening.  This will secure 

the hood body to the cabinet base and prevent the hood 

from shifting after installation.

12) Place front panel back on hood body and secure in  

      place by using the (10) screws previously removed from  

      step 2.