Zephyr ZGEE30AS オーナーマニュアル

www.zephyronline.com

 To assure continued compliance, any changes or modif cations not expressly approved by the party 

responsible for compliance could void the user’s authority to operate this equipment.  This device complies with Part 

15 of the FCC Rules. Operation is subject to the following two conditions.  (1) This device may not  cause harmful 

interference, and (2) This device must accept any interference received, including interference that may cause 

undesired operation.

                                                                                                                                        

This remote control may operate in humid environments, but not when placed on a wet surface.                                                  

The RF remote control is equipped with a magnet for easy storage.  The remote             
may be placed on any magnetic surface such as a refrigerator or the Zephyr  

          

remote holder.  Maximum remote control communication distance from hood is 15ft.

          

Clean the remote control using non abrasive detergents

                                                        

          

Using a small f at head screwdriver, raise the cover of the battery door (A) in order    

                     

to access the battery compartment.

          

Remove the battery and replace with Type A23 12V.                                                           

          

Negative end of battery should face the spring inside the remote.

         Replace battery door and recycle old battery.

         1.  Place remote control on the counter near the hood (make sure a good battery is installed).
         2.  Disconnect power from the hood by turning off circuit breaker.
         3.  Reconnect power to the hood.

         Follow this procedure whenever the remote control does not work.

By pressing      , the blower is switched On.  Press        again to cycle through all 
three blower speeds. 

By pressing      , the blowers will power on at the last speed setting.  Press 
again and the entire hood will power off, including lights.

Switch lights On by pressing       once, again to dim and again to switch Off.

Blower On/

Speed Selection

1

1

2

3

4

Blower On/
Power Off

2

5 Min Delay Off

3

Lights On/Dim/Off

4

By pressing      , the blower and lights will enter Delay Off mode.  A dot will 
appear in the lower right corner of the power pack display        indicating the 
function is on.  The blower will change to speed 1 and shut down after 5 
minutes.

-

+