Maytag MEDB855D インストール手順

Remove center terminal block screw (B). Remove neutral 

ground wire (E) from external ground conductor screw (A).

You must verify with a qualified  electrician that this grounding 

method is acceptable before connecting.

Connect neutral ground wire (E) and neutral wire (white or 

center wire) (C) of power supply cord or cable under center 

terminal block screw (B). Tighten screw.

Place hooked ends of remaining wires under outer terminal 

block screws (hooks facing right). Tighten screws. 

Connect a separate copper ground wire (G) from the external 

ground conductor screw (A) to an adequate ground. Finally, 

reinsert tab of terminal block cover into slot of dryer rear 

panel. Secure cover with hold-down screw. Now, go to 

“Venting Requirements.”