Electrolux EI23BC35KS オーナーマニュアル

Your refrigerator is equipped with separate water and 

air filtering systems. The water filter system filters all 

dispensed drinking water, as well as the water used to 

produce ice. The air filter removes odors and impurities 

from the refrigerator compartment.

The control panel includes controls to monitor the 

status of your water and air filters. See the Controls 

section for more information.

The 

TM

 NGFC 2000 ice and 

water filter system is tested and certified by NSF 

International to NSF/ANSI Standards 42 and 

53 for the reduction of claims specified on the 

performance data sheet. 

The water filter is located at the lower left side of the fresh 

food compartment. 

In general, you should change the water filter every six (6) 

months to ensure the highest possible water quality. The 

Water Filter Status light on the Touch Panel prompts you 

to replace the filter after a standard amount of water (400 

gallons)

 

has flowed through the system.

If your refrigerator has not been used for a period of time 

(during moving for example), change the filter before 

reinstalling the refrigerator.

It is not necessary to turn the water supply off to change 

the filter. Be ready to wipe up any small amounts of water 

released during the filter replacement.
 

1 Turn 

Off the ice maker on the control panel.   

 

2   Push the filter release button above the cartridge 

to disconnect it.

 

3  Slide the old water filter cartridge straight out of the 

housing and discard it.

 

4  Unpack the new filter cartridge and remove the 

two (2) protective caps covering the inlet and exit 

of the filter.  Slide the filter gently into the housing 

until it stops against the snap-in connector at the 

back of the housing.

Do not use with water that is microbiologically unsafe or of 

unknown quality without adequate disinfection before or after 

the system. Systems certified for cyst reduction may be used 

on disinfected waters that may contain filterable cysts. 

 •  Rated Capacity - 400 gallons for

TM

 ice and water filter

 •  Rated service flow - .5 gallons per minute
 •  Maximum Rated Pressure - 100 pounds per

square inch

 •  Recommended Minimum Operating Pressure: 30

pounds per square inch

 •  Operating Temp.: Min. 33°F, Max. 100°F

 

5  Push firmly until the cartridge snaps into 

place (you should hear two clicks). When fully 

engaged, the front of the filter cartridge should be 

flush with the filter release button.

 

6 Turn 

On the ice maker at the control panel.

 

7  Press a drinking glass against the water dispenser 

while checking for any leaks at the filter housing. 

Spurts and sputters may occur as the system 

purges air out of the dispenser system.

 

8  Prime the water supply system as            

described previously.

 

9  Press and hold the Filter Status button on the 

control panel for three (3) seconds. When the 

display changes from “

Replace” to “Good,” the 

status has been reset.