Electrolux EI23BC80KS オーナーマニュアル

If you experience a concern with your refrigerator or notice a product behavior or condition that you do not 

understand, you can usually avoid a call to your service representative by referring to this section for an answer. 

Beginning with the following table, this information includes concerns, potential causes, and common solutions.

•  Ice maker is turned off.
•  Refrigerator is not connected to water line 

or water valve is not open.

•  The water supply line is kinked. 

•  The water filter is not seated properly. 

 

•  The water filter may be clogged with 

foreign material.

•  Saddle valve on cold water pipe is 

clogged or restricted by foreign material.

•  Lower the wire signal arm. 
•  Connect the unit to the household water supply 

and ensure the supply valve is open.

•  Ensure that the supply line does not kink when the 

refrigerator is pushed into place against the wall.

•  Remove and re-install the water filter. Be sure to 

push the filter firmly so that you hear it lock solidly 

into position.

•  If water dispenses slowly or not at all, or if the filter 

is six months old or older, it should be replaced.

•  Turn off household water line valve. Remove valve. 

Ensure that valve is not a self-piercing saddle 

valve. Clean valve. Replace valve if necessary.

•  Ice maker is producing less ice than you 

expect. 

•  The water filter may be clogged with 

foreign material.

•  The water supply line is kinked. 

•  Saddle valve on cold water pipe is 

clogged or restricted by foreign material. 

•  Freezer control is set too warm.

•  The freezer ice maker will produce approximately 

2.5 pounds of ice every 24 hours depending on 

usage conditions.

•  If the filter is six months old or older, it should be 

replaced.

•  Ensure that the supply line does not kink when the 

refrigerator is pushed into place against the wall.

•  Turn off household water line valve. Remove valve. 

Ensure that valve is not a self-piercing saddle 

valve. Clean valve. Replace valve if necessary.

•  Set freezer control to colder setting to improve 

performance of the ice maker. Allow 24 hours for 

temperature to stabilize.

•  Ice maker wire signal arm is being held 

down by some package in the freezer that 

has fallen against the ice maker.

•  Move the item and release wire signal arm. 

Remove any ice cubes that may have frozen 

together over the wire signal arm.

•  Ice cubes are not being used frequently 

enough. 

•  Ice cubes are hollow (shells of ice with 

water inside). The hollow cubes break open 

in the bin and leak their water onto existing 

ice, which causes it to freeze together.

•  Remove ice container and discard ice. The ice maker 

will produce fresh supply. Ice should be used at 

least twice weekly to keep the cubes separated.

•  This generally occurs when the ice maker does not 

get enough water. This is usually the result of a 

clogged water filter. Replace the water filter.