Thermador WDC36J インストール手順
4. Secure with three (3) 3/4” (3.175 mm) Phillips head
screws (included).
5. Insert plug into three-prong, grounded outlet (see
6. Slide warming drawer assembly into cutout until it is
flush with cabinet. Take care that the side screws of
the warming drawer do not scratch the cabinet.
the warming drawer do not scratch the cabinet.
7. Drill pilot holes through side flange holes with a 1/8”
(3.175 mm) wood bit.
8. Secure with four (4) stainless Phillips screws through
9. Turn power on at the service panel.
10. Turn the warming drawer on. Indicator light and timer
10. Turn the warming drawer on. Indicator light and timer
should turn on immediately. Close the drawer for
approximately 30 seconds then check for warmth.
approximately 30 seconds then check for warmth.
Figure 8: Anti-tip Bracket Location
20⅝” (524 mm)
=
=
20⅝”
(524 mm)
(524 mm)
Figure 9: Secure Warming Drawer