Frigidaire FGHF2366PF 使用とお手入れ

13

Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.



All set screws should be tightened so the screw is below the surface of the handle. The handles 

should be drawn tight to freezer and refrigerator doors with no gaps. Opening the opposite door 

while tightening the Allen screw makes installation easier.
The door handle may loosen over time or if it was installed improperly. If this happens, tighten the 

set screws on the handles.

  1  Remove handles from carton and 

any other protective packaging.

  2  Position fresh food handle end caps 

over upper and lower pre-installed 

shoulder bolts (A) that are fastened 

into door, ensuring the holes for the 

set screws are facing towards the 

opposite door.

 3  While holding handle firmly against

door, fasten upper and lower Allen set 

screws (B) with supplied Allen wrench.

  4  Repeat steps 2 and 3 to install 

opposite handle. Ensure the holes 

for the set screws are facing 

towards the first door.

  5  Position freezer handle end caps 

over left and right pre-installed 

shoulder bolts that are fastened to 

the door, ensuring the holes for the 

set screws are facing down.

 6  While holding handle firmly against

door, loosely tighten right Allen 

set screw (B) with supplied Allen 

wrench until there is no gap 

between handle and door.

 7  Still holding the handle firmly to the

door, firmly tighten left Allen set

screw (B) with supplied Allen wrench.

  8  Return to the right Allen set screw 

(B) and firmly tighten with supplied

Allen wrench.