Frigidaire FGHF2366PF 使用とお手入れ

17

After connecting the water supply, refer to 

“How to Prime the Water Supply System” for 

important information about priming an empty 

water supply system.
Your refrigerator’s water supply system includes 

several tubing lines, a water filter, a water

valve, and a water tank. To ensure that your 

water dispenser works properly, this system 

must be completely filled with water when your

refrigerator is first connected to the household

water supply line.

Steel

Clamp

Brass

Compression

Nut

Water Line

Water Valve

Bracket

Valve Inlet

Water Valve

Water line from household

water supply

(Include enough tubing in loop to allow

moving refrigerator out for cleaning.)

Ferrule

(Sleeve)

Plastic Water Tubing

to Ice Maker

Fill Tube

  1  Disconnect refrigerator from electric power 

source.

  2  Place end of water supply line into sink or 

bucket. Turn ON water supply and flush

supply line until water is clear. Turn OFF water 

supply at shutoff valve.

  3  Remove plastic cap from water valve inlet and 

discard cap.

  4  If you use copper tubing - Slide brass 

compression nut, then ferrule (sleeve) onto 

water supply line. Push water supply line 

into water valve inlet as far as it will go 

(¼ inch/6.4 mm). Slide ferrule (sleeve) into 

valve inlet and finger tighten compression nut

onto valve. Tighten another half turn with a 

wrench; DO NOT over tighten. See Figure 1.

    If you use stainless steel tubing - The nut and 

ferrule are already assembled on the tubing. 

Slide compression nut onto valve inlet and 

finger tighten compression nut onto valve.

Tighten another half turn with a wrench; DO 

NOT over tighten. See Figure 1.

  5  With steel clamp and screw, secure water 

supply line (copper tubing only) to rear panel 

of refrigerator as shown.

  6  Coil excess water supply line (copper tubing 

only), about 2½ turns, behind refrigerator 

as shown and arrange coils so they do not 

vibrate or wear against any other surface. Do 

not kink tubing.

  7  Turn ON water supply at shutoff valve and 

tighten any connections that leak.

  8  Reconnect refrigerator to electrical power 

source.

  9  To turn ice maker on, lower wire signal arm 

(freezer ice maker) or set the ice maker’s On/

Off power switch to the “On” position (fresh 

food ice maker).