Frigidaire FGHF2366PF 使用とお手入れ

Your ice maker is turned on at the factory so it 

can work as soon as you install your refrigerator. 

If you cannot connect a water supply, set the 

ice maker’s On/Off icon to Off; otherwise, the 

ice maker’s fill valve may make a loud chattering

noise when it attempts to operate without water.

On occasion, unusually small ice cubes may 

be noticed in the bucket or in dispensed ice. 

This could occur in normal operation of the 

ice maker. If you start seeing these more 

frequently, it may be an indication of low

water pressure or the water filter needs to be

replaced. As the water filter nears the end of its

useful life and becomes clogged with particles, 

less water is delivered to the ice maker during 

each cycle. Remember, if it’s been six months or 

longer since you last changed your water filter,

replace the water filter with a new one. Poor

quality household water may require the filter

to be changed more frequently.

Turning off the ice maker simply disables ice 

making. You will still be able to dispense existing 

ice, and you will still be able to dispense water.

21



The water dispenser has a built-in device that 

shuts off the water flow after three minutes of

continuous use. To reset this shutoff device, 

simply release the dispenser paddle.



The ice maker also has a built-in plastic signal 

arm that automatically stops ice production 

when the ice bin is full. This signal arm should 

not be used to manually stop the ice maker.

For proper dispenser operation, recommended 

water supply pressure should fall between 

30 psi and 100 psi. Excessive pressure may 

cause the system to malfunction.

 1  Begin filling the system by pressing and

holding a drinking glass against the water 

dispenser paddle.

  2  Keep the glass in 

this position until 

water comes out 

of the dispenser. 

It may take about 

1½ minutes.

 3 Continue 

dispensing water 

for about four 

minutes to flush

the system and 

plumbing connections of any impurities 

(stopping to empty the glass as necessary).

After the refrigerator is installed properly and 

has cooled for several hours, the ice maker can 

produce ice within 24 hours. The ice maker will fill

the ice bin from the rear. You must dispense some 

ice to force the ice forward in the bin. This will 

allow the bin to fill completely.

This ice maker should produce 2.5 to 3 pounds of 

ice per 24 hours.
In a Standard Depth model, the ice bin will hold 

about 6.5 pounds of ice. In a Counter Depth 

model, the ice bin will hold about 4 pounds of ice.

Ice production is controlled by the ice maker’s  

On/Off icon on the control panel. Touch the 

“options” button to access the Options Menu on 

the control panel. Use "∨” or "∧” to select the ice 

maker. Then use “+” or “-” to select ON or OFF. 

Touch “set” to activate your choice.

Before making ice for the first time, be sure

to prime the water supply system. Air in new 

plumbing lines can result in two or three empty 

ice maker cycles. Furthermore, if the system is not 

flushed, the first ice cubes may be discolored or

have an odd flavor.



Dispensed water is chilled. For colder water, add 

ice to cup or container before dispensing water.