Frigidaire FGHF2366PF 使用とお手入れ

24

If the water supply to your refrigerator is 

softened, be sure the softener is properly 

maintained. Chemicals from a water softener 

can damage the ice maker.

NEVER use an ice pick or similar sharp 

instrument to break up the ice. This could 

damage the ice bin.
To loosen stuck ice, use warm water. Before 

replacing the ice bin, make sure it is completely dry.

Clean the ice maker and ice bin at regular 

intervals, especially prior to vacation or moving.
  1  Turn off the ice maker.
  2  Remove the ice bin.
  3  Empty and carefully clean the ice bin with 

mild detergent. Do not use harsh or abrasive 

cleaners. Rinse with clean water.

  4  Allow the ice bin to dry completely before 

replacing in the freezer.

  5  Replace the ice bin. Turn the ice maker on.
Remove and empty the ice bin if an extended 

power failure (one hour or longer) causes ice 

cubes in the ice bin to melt and refreeze together 

after power is restored.
Remove the ice bin and shake to loosen the cubes 

or clean as explained above.

•  The following sounds are normal when the ice 

maker is operating:

 

-  Motor running

 

-  Ice dropping into ice bin

 

-  Water valve opening or closing

 

-  Running water

•  Ice cubes stored too long may develop an odd 

flavor. Empty the ice bin as explained below.

Your refrigerator is equipped with a Quick Freeze

Function for freezing food at a faster rate, but it can 

also increase ice production. This function terminates 

automatically after 12 hours. This function affects 

only the ice maker in the freezer.

Your ice maker is turned on at the factory 

so it can work as soon as you install your 

refrigerator. If you cannot connect a water 

supply, lift the ice maker’s wire signal arm to 

turn it off. Otherwise, the ice maker’s fill valve

may make a loud chattering noise when it 

attempts to operate without water.

Ice production is controlled by lifting/lowering the 

ice maker’s wire signal arm. To gain access to the 

ice maker, pull the freezer drawer out. Lift the wire 

signal arm to turn the ice maker OFF and lower 

the wire signal arm to turn it ON.

Wire

Signal Arm

After the refrigerator is installed properly, the ice 

maker can produce ice within 24 hours. When 

using the ice maker for the first time, and in order

for it to work properly, it is necessary to clear air 

from the water tubing and the filter. Furthermore,

if the system is not flushed, the first ice cubes

may be discolored or have an odd flavor. Once the

ice maker begins making ice, allow the bin to fill

completely, then discard the first FULL bin of ice

on a Standard Depth model, and the first TWO

FULL bins of ice on a Counter Depth model.

This ice maker should produce between 2 and 2.5 

pounds of ice per 24 hours depending on usage 

conditions. In a Standard Depth model, the ice 

bin will hold about 12 pounds of ice. In a Counter 

Depth model, the ice bin will hold about 7 pounds 

of ice.