Frigidaire FFHN2740 オーナーマニュアル

6

Toe Grille Must

Fit in Slot on

Anti-tip Bracket

Screw/Washer

Assembly

(3) Retaining Clips

rollers (select models):
  1  Slightly open freezer drawer. Lift the 

toe grille and gently pull forward (see 

illustration).

 2  You can raise or lower each door. Use a ⅜

inch socket wrench to turn the adjustment 

screws (one per side).

  1  Check gasket seal around top, bottom, 

and sides of freezer drawer.

  2  If gasket is not sealed, open drawer and 

slightly loosen four drawer screws (two on 

each side) to allow drawer to rotate.

  3  Close drawer and recheck the seal on the 

gasket (A). Open the drawer grabbing by 

the sides in the center (B). Be careful not 

to rotate the drawer.

  4  Tighten four drawer screws.
  5  Recheck gasket seal.

Push

Against

Freezer

Drawer

Grab Drawer

At Center

From Both

Sides Then

Pull Drawer

Out

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Do Not Remove

Other Screws

Do Not Remove

Other Screws

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Raise

Lower

Anti-tip

Leg

Door

Door

 5  Install the toe grille by fitting into place.

•  All four corners of the cabinet must rest 

firmly on the floor.

•  The sides should tilt ¼ inch (6 mm) from 

front to back (to ensure that doors close 

and seal properly).

•  Doors should align with each other and be 

level.

Most of these conditions can be met by raising 

or lowering the adjustable front rollers.

    To raise: turn adjustment screw clockwise.
    To lower: turn adjustment screw 

counterclockwise.

  3  Ensure both doors are bind-free with their 

seals touching the cabinet on all four sides 

and that cabinet is stable.

  4  After unit is leveled, lower anti-tip leg until 

it contacts the floor.