Frigidaire FCRS181RQB オーナーマニュアル

The appliance comes with 4 casters; 2 with locks 

for the front of the unit and 2 without locks for 

the back of the unit. The casters allow you to 

move the unit to it’s final destination with ease. 

The casters can then be locked into place.  

Refer to the First Steps section for caster 

installation instructions.

The adjustable cold control is located on the top 

left side of the evaporator housing inside the 

unit. “5” is the medium (recommended) setting 

and “9” is the coldest setting.

Once the appliance has been located in its 

permanent location and the proper power and 

grounding has been provided, the following 

items must be checked or completed:

For safe food storage, allow 24 hours for the 

appliance to cool down completely before loading 

with food. The appliance will run continuously 

for the first several hours. Do not place any food 

in the appliance until after the first 24 hours of 

operation.

Figure 6

•  Heavy-duty epoxy powder-coated 

adjustable shelves

•  NSF-certified top-mounted evaporator

•  2-½” urethane foam cabinet insulation

•  Torsion-spring door closer
•  Heavy-duty fixed and swivel casters
•  17-watt fluorescent lamp
•  Stainless steel evaporator housing

•  Removable stainless steel drain cover
•  Adjustable temperature control
•  NSF-certified interior

•  Heavy-duty front grill

•  Heavy-duty commercially rated electrical 

harness

•  Heavy-duty removable stainless steel shelf 

support

Regular

Shelves

Shallow

Shelf

Bottom

Shelf

This appliance is provided with 4 shelves. One 

goes on the floor of the cabinet and the other 3 

are placed in the metal side supports wherever 

they are needed. The shallow shelf goes in the 

upper position.

The appliance is shipped from the factory with 

the thermostat set at about the mid-point of the 

operating range. Adjustments colder or warmer 

can be made after the appliance has been running 

for at least 8 hours. Allow at least 8 hours for 

temperature stabilization before re-adjusting the 

thermostat.

The appliance is designed to defrost 

automatically every 12 hours. To set the time of 

defrost, wait until the desired time to defrost. 

With the notch on the timer knob aligned with 

the line on the bracket (Figure 6), turn the 

defrost timer knob clockwise slowly. The timer 

will click several times, then once loudly, at 

which point the defrost cycle begins. The timer 

knob will advance through the defrost cycle, then 

click loudly at the end of the cycle. The appliance 

will defrost automatically every 12 hours after 

the first defrost cycle.

For example, to set the appliance to defrost 

at 10:00 AM, turn the timer knob clockwise 

at 10:00 AM until the timer clicks loudly. The 

appliance will defrost daily at 10:00 AM and 

again 12 hours later at 10:00 PM. NOTE: The 

appliance interior temperature will rise slightly 

during the first defrost cycle.