Viking RVRF336SS 使用とお手入れ

ページ / 32
22
Changing The Water and Air Filters
Your refrigerator is equipped with separate water and air 
fi ltering systems. The water fi lter system fi lters all the water 
used to produce ice. The air fi lter removes odors and 
impurities from the refrigerator compartment.
Push Water Filter Button
NOTE
The control panel includes controls to monitor the status of 
your water and air fi lters. See the Controls section for more 
information.
About your advanced water fi lter
The NGFC-2000 fi lter system is tested and 
certifi ed by NSF International to NSF/ANSI 
Standards 42, 53 and 401 for the reduction 
of claims specifi ed on the performance data 
sheet.
Do not use with water that is microbiologically unsafe or of 
unknown quality without adequate disinfection before or 
after the system. Systems certifi ed for cyst reduction may 
be used on disinfected waters that may contain fi lterable 
cysts.
  •  Rated Capacity - 240 gallons
  •  Rated service fl ow - .5 gallons per minute
  •  Maximum Rated Pressure - 100 pounds per square 
inch
  •  Recommended Minimum Operating Pressure: 30 
pounds per square inch
  •  Operating Temp.: Min. 33°F, Max. 100°F
Water fi lter
The water fi lter is located at the lower left side of the fresh 
food compartment.
Replacing your TruWater water fi lter
In general, you should change the water fi lter every six 
months to ensure the highest possible water quality. The 
Water
 
Filter Status
 light on the Touch Panel prompts 
you to replace the fi lter after the six month time period has 
elapsed. The water fi lter status light on this model is not 
performance tested or certifi ed by NSF.
If your refrigerator has not been used for a period of time 
(during moving for example), change the fi lter before 
reinstalling the refrigerator.
It is not necessary to turn the water supply off to change 
the fi lter. Be ready to wipe up any small amounts of water 
released during the fi lter replacement.
 
1
  Push the fi lter release button above the cartridge to 
disconnect it.
 
2
  Slide the old water fi lter cartridge straight out of the 
housing and discard it.
 
3
  Unpack the new fi lter cartridge and remove the two 
protective caps covering the inlet and exit of the 
fi lter. Slide the fi lter gently into the housing until it 
stops against the snap-in connector at the back of the 
housing.