AGA AMLFDR23SS オーナーマニュアル

12

Drawer is heavy. Use caution when lifting.

1.  Open freezer drawer.

2.  Remove drawer screws on right and left sides (two 

screws on each side).

3.  Lift drawer up and out to remove.

1.  With lower slides pulled out, hang drawer onto slide 

brackets ensuring pins on each side are fully inserted 

into slots on each side.

2.  Reinstall four drawer screws (two per side), tighten 

down, and close drawer (C).

3.  Check gasket seal around top, bottom, and sides of 

freezer drawer. 

4.  If gasket is not sealed, open drawer and slightly loosen 

four drawer screws (two on each side) to allow drawer 

to rotate.

5.  Close drawer and recheck the seal on the gasket (A). 

Open the drawer grabbing by the sides in the center 

(B). Be careful not to rotate the drawer.

6.  Tighten four drawer screws.

7.  Recheck gasket seal.

8.  Install the toe grille by fitting into place.

Assembly

Pin

Fully extend

drawer slides

Cabinet

Slot

Install 

screws

(2) each

side

Push

against

freezer

drawer

Grab drawer 

at center

from both

sides, then

pull drawer out

Do not remove

other screws

Remove hex

head drawer

screw

Remove 

hex

head drawer

screw

Remove 

hex

head drawer

screw

Remove hex

head drawer

screw

Figure 25

Figure 26

Figure 24

Figure 23