Electrolux EI24RD10QS オーナーマニュアル

Removing the Drawer

WARNING

ELECTROCUTION HAZARD
• Never attempt to repair or perform maintenance on the appliance until the

main electrical power has been disconnected. Turning the appliance control

“OFF” does not remove electrical power from the units wiring.

• Replace all parts and panels before operating.

Remove Drawers from unit

Begin by pulling out the top drawer. (See

Figure 9). Remove screws securing drawer

to slides (See Figure 10). Pull drawer

forward, lift up and out to clear clips in rear of

drawer. Move drawer forward about 1" (2.5

cm) and set down on slides. At the right rear

corner of the drawer disconnect the display

wire harness (See Figure 9a). Remove

the drawer from the unit by lifting up off of

the slides. Repeat for bottom drawer but

disregard the harness instructions as there is

no wiring to the bottom drawer.

To replace the air filter:

Fully extend the bottom drawer. The air filter is located on the left lower wall of the cabinet.

Remove the old air filter and replace with a new air filter. See Figure 11.

Filter

housing

Air Filter

Figure 11

Press and hold

down this tab on

the wire connector

and pull the

connector apart.

Figure 9a

Figure 9

Remove screws

Clips

Gasket

Figure 10