Frigidaire FFHN2740PE オーナーマニュアル

10

Be sure doors are set aside in a secure 

position where they cannot fall and cause 

personal injury, or damage to the doors or 

handles.

Drawer is heavy. Use caution when lifting.

Once both doors are in place, ensure they are 

aligned with each other and level (Please see 

the “Installation” section for more details), and 

replace the top hinge cover.

  4  Unscrew the three lower hinge screws and 

hinge if necessary.

To reinstall the right door, reverse the above 

steps.

Removing Freezer Drawer
  1  Open freezer drawer.
  2  Remove drawer screws on right and left 

sides (two screws on each side).

  3  Lift drawer up and out to remove.

Installing Freezer Drawer
  1  With lower slides pulled out, hang drawer 

onto slide brackets ensuring pins on each 

side are fully inserted into slots on each side.

  6  Tighten four drawer screws.
  7  Recheck gasket seal.
 8  Install the toe grille by fitting into place.

  2  Reinstall four drawer screws (two per 

side), tighten down, and close drawer (C).

Push

Against

Freezer

Drawer

Grab Drawer

At Center

From Both

Sides Then

Pull Drawer

Out

Assembly

 

Drawer Slides

Pin

Slot

Cabinet

Drawer

Fully Extend  

Install Screws

(2) Each Side

  3  Check gasket seal around top, bottom, 

and sides of freezer drawer.

  4  If gasket is not sealed, open drawer and 

slightly loosen four drawer screws (two on 

each side) to allow drawer to rotate.

  5  Close drawer and recheck the seal on the 

gasket (A). Open the drawer grabbing by 

the sides in the center (B). Be careful not 

to rotate the drawer.



You will be pulling approximately three 

feet of water tube from the back of the 

refrigerator.

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Do Not Remove

Other Screws

Do Not Remove

Other Screws

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw