Frigidaire FFHN2740PE オーナーマニュアル

25

Your refrigerator is equipped with water

filtering system. The water filter system filters

all dispensed drinking water, as well as the 

water used to produce ice.

The water filter is located at the top right side

of the fresh food compartment.

To order your replacement filters, please visit

our online store at www.frigidaire.com/store, 

by calling toll-free at 877-808-4195, or by 

visiting the dealer where you purchased your 

refrigerator. Frigidaire recommends that you 

order extra filters when you first install your

refrigerator, and that you replace your filters at

least once every six months.
Here is the product number to request when

ordering:
  PureSource Ultra

TM 

Water Filter

  Part #ULTRAWF

In general, you should change the water 

filter every six months to ensure the highest

possible water quality. The Water Filter 

Status light on the user interface prompts you 

to replace the filter after a standard amount of

water (200 gallons/757 liters for PureSource 

)

 

has flowed through the system. The

water filter status light on this model is not

performance tested or certified by NSF.
If your refrigerator has not been used for a 

period of time (during moving for example), 

change the filter before reinstalling the

refrigerator.

Filter Cartridge

Do not use with water that is microbiologically 

unsafe or of unknown quality without adequate

disinfection before or after the system. Systems 

certified for cyst reduction may be used on

disinfected waters that may contain filterable cysts.

•  Rated Capacity - 200 gallons/757 liters for 

ice and water filter

•  Rated service flow - .50 gallons per minute
•  Operating Temp.: Min. 33° F, Max. 100° F
•  Maximum Rated Pressure - 100 pounds per 

square inch

•  Recommended Minimum Operating Pressure: 

30 pounds per square inch

It is not necessary to turn the water supply off 

to change the filter. Be ready to wipe up any

small amounts of water released during the filter

replacement.
  1  Turn Off the ice maker by raising the wire 

signal arm.

 2  Remove the filter by pushing on the end/

face of the filter.

 3  Slide the old water filter cartridge straight

out of the housing and discard it.

 4  Unpackage the new filter cartridge. Using

the alignment guide, slide it gently into the 

filter housing until it stops against the snap-in

connector at the back of the housing.

 5  Push firmly until the cartridge snaps into

place (you should hear a click as the 

cartridge engages the snap-in connector).

  6  Turn On the ice maker by lowering the wire 

signal arm.

  7  Press and hold the Water Filter button on the 

Ice & Water Dispenser control panel for three 

seconds. When the display changes from Red 

to Green, the status has been reset.

 8  After replacing the water filter and in order for

the ice maker to work properly, it is necessary 

to clear air from water filter tubing. Once ice

maker begins making ice, allow the bucket to 

fill completely, then discard the first TWO FULL

buckets of ice. It will take at least two days 

to completely fill the bucket on regular ice

making mode or 1½ days on fast ice mode.

The PureSource Ultra

 ice 

and water filter system is tested

and certified to NSF/ANSI

Standards 42 and 53 for the 

reduction of claims specified on

the performance data sheet.