Frigidaire FGHB2866PP オーナーマニュアル

30

Visit our web site at

1-800-944-9044 (United States)

1-800-265-8352 (Canada)

Ice maker is not 

making any ice.

•  Ice maker is turned off. 

 

 

•  Refrigerator is not 

connected to water line or 

water valve is not open.

•  The water supply line is 

kinked.

•  The water filter is not

seated properly. 

•  The water filter may be

clogged with foreign 

material.

•  Freezer ice maker wire 

signal arm is being held 

up by an item not allowing 

it to go in the on or down 

position.

•  Turn on ice maker. For the fresh food ice maker, 

press and hold the “Ice Off” button for three seconds 

until the indicator light is off. For the freezer ice 

maker, lower the wire signal arm.

•  Connect the unit to the household water supply and 

ensure the water valve is open. 

•  Ensure that the supply line does not kink when the 

refrigerator is pushed into place against the wall.

•  Remove and re-install the water filter. Be sure to

push the filter firmly so that you hear it lock solidly

into position.

•  If water dispenses slowly or not at all, or if the filter

is six months old or older, it should be replaced. 

•  Move any item or frozen ice cubes that may block 

the signal arm from being in the on or down position. 

See Automatic Ice Maker-Freezer section in manual.

Ice maker is not 

making enough ice.

•  Ice maker is producing less 

ice than you expect. 

•  The water filter may be

clogged with foreign 

material.

•  The water supply line is 

kinked.

•  Saddle valve on cold water 

pipe is clogged or restricted 

by foreign material.

•  Heavy traffic, opening

or closing of the doors 

excessively.

•  Freezer control is set too 

warm (freezer ice maker).

•  The fresh food and freezer ice makers will each 

produce approximately 2.5 pounds of ice every 24 

hours depending on usage conditions.

•  If water dispenses slower than normal, or if the filter

is six months old or older, it should be replaced. 

•  Ensure that the supply line does not kink when the 

refrigerator is pushed into place against the wall.

•  Turn off household water line valve. Remove valve. 

Ensure that valve is not a self-piercing saddle valve. 

Clean valve. Replace valve if necessary.

•  Press Fast Freeze to temporarily increase ice 

production rate. 

•  Set freezer control to colder setting to improve 

performance of the ice maker (freezer ice maker). 

Allow 24 hours for temperature to stabilize.

Freezer ice maker will 

not stop making ice 

(select models).

•  Ice maker wire signal arm 

is being held down by a 

package in the freezer that 

has fallen against ice maker.

•  Move any item or frozen ice cubes that may block the 

signal arm from being in the off or upward position. 

See Automatic Ice Maker-Freezer section in manual.

Ice cubes are freezing 

together.

•  Ice cubes are not being 

used frequently enough or 

interruption of power for 

prolonged time.

•  Ice cubes are hollow (shells 

of ice with water inside). 

The hollow cubes break 

open in the bin and leak 

their water onto existing ice, 

which causes it to freeze 

together.

•  Remove ice container and discard ice. The ice maker 

will produce fresh supply. Ice should be used at least 

twice weekly to keep the cubes separated. 

•  This generally occurs when the ice maker does 

not get enough water. This is usually the result of 

a clogged water filter or restricted water supply.

Replace the water filter and if the condition still

occurs check for a Saddle Valve, water valve not 

turned on all the way or kinked water supply line.