Frigidaire FGHB2866PP オーナーマニュアル

6

Toe Grille Must

Fit in Slot on

Anti-tip Bracket

Screw/Washer

Assembly

(3) Retaining Clips

lowering the adjustable front rollers.
To level the cabinet using the front rollers:
  1  Slightly open freezer drawer. Lift the toe grille and 

gently pull forward (see illustration).

To level the freezer drawer:
  1  Check gasket seal around top, bottom, and sides of 

freezer drawer.

  2  If gasket is not sealed, open drawer and slightly 

loosen four drawer screws (two on each side) to 

allow drawer to rotate.

  3  Close drawer and recheck the seal on the gasket 

(A). Open the drawer grabbing by the sides in the 

center (B). Be careful not to rotate the drawer.

  4  Tighten four drawer screws.
  5  Recheck gasket seal.

•  All four corners of the cabinet must rest firmly on the

floor.

•  The sides should tilt 

1

/

4

 inch (6 mm) from front to 

back (to ensure that doors close and seal properly).

•  Doors should align with each other and be level.

Push Against

Freezer Drawer

Grab Drawer

At Center

From Both Sides

Then

Pull Drawer Out

Raise

Lower

Anti-tip

Leg

Door

Door

  2  You can raise or lower each door. Use a 3/8 inch 

socket wrench to turn the adjustment screws  

(1 per side).

  

To raise: turn adjustment screw clockwise.

  

To lower: turn adjustment screw counterclockwise.

  3  Ensure both doors are bind-free with their seals 

touching the cabinet on all four sides and that 

cabinet is stable.

  4  After unit is leveled, lower anti-tip leg until it 

contacts the floor.

  5  Install the toe grille by fitting into place.

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Do Not Remove

Other Screws

Do Not Remove

Other Screws

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw