Frigidaire FGHB2866PF オーナーマニュアル

31

Dispenser will not 

dispense ice.

•  Dispenser lock out is engaged.
•  There is no ice in the bin to 

be dispensed.

•  The refrigerator doors are 

not completely closed.

•  Dispenser paddle has 

been pressed too long and 

the dispenser motor has 

overheated.

•  Press and hold control lock for three seconds.
•  See the “Ice maker is not making any ice” section 

above.

•  Be sure the refrigerator doors are completely closed. 

•  The motor overload protector will reset in about 

three minutes and then ice can be dispensed.

Ice dispenser is 

jammed.

•  Ice has melted and frozen 

around auger due to infrequent 

use, temperature fluctuations,

and/or power outages.

•  Ice cubes are jammed 

between ice maker and back 

of ice container.

•  Remove ice container, thaw, and empty the contents. 

Clean container, wipe dry, and replace in proper 

position. When new ice is made, dispenser should 

operate.

•  Remove ice cubes that are jamming the dispenser.

Dispenser will not 

dispense water.

•  Dispenser lock out is engaged.
•  Water filter not seated

properly.

•  Water filter is clogged. 

 

•  Household water line valve 

is not open.

•  Press and hold control lock for three seconds.
•  Remove and reinstall the water filter. Be sure to push the

filter firmly so that you hear it lock solidly into position.

•  Replace filter cartridge. Be sure to remove protective

caps and push the filter firmly so that you hear it lock

solidly into position.

•  Open household water line valve. See CONCERN 

column AUTOMATIC ICE MAKER.

Water has an odd taste 

and/or odor.

•  Water has not been dispensed 

for an extended period of time.

•  Unit not properly connected 

to cold water line.

•  Draw and discard 10-12 glasses of water to freshen 

the supply.

•  Connect unit to cold water line that supplies water to 

the kitchen faucet.

Water pressure is 

extremely low.

•  Cut-off and cut-on pressures 

are too low (well systems only).

•  Reverse osmosis system is 

in regenerative phase.

•  Have someone turn up the cut-off and cut-on pressure 

on the water pump system (well systems only).

•  It is normal for a reverse osmosis system to be below 

20 psi during the regenerative phase.

Water not cold enough.

•  As warmer tap water goes 

through the filter and enters

the water tank, chilled 

water is pushed through to 

the dispenser. Once chilled 

water is used up, it will take 

several hours to bring the 

freshly replaced water to a 

cooler temperature.

•  Add ice to cup or container before dispensing water.

Door(s) will not close.

•  Door was closed too hard, 

causing other door to open 

slightly.

•  Refrigerator is not level. 

It rocks on the floor when

moved slightly.

•  Refrigerator is touching a 

wall or cabinet.

•  Close both doors gently. 

 

•  Ensure floor is level and solid, and can adequately

support the refrigerator. Contact a carpenter to 

correct a sagging or sloping floor.

•  Ensure floor is level and solid, and can adequately

support the refrigerator. Contact a carpenter to 

correct a sagging or sloping floor.

Drawers are difficult to

move.

•  Food is touching shelf on 

top of drawer.

•  Track that drawers slide on 

is dirty.

•  Remove top layer of items in drawer.
•  Ensure drawer is properly installed on track.
•  Clean drawer, rollers, and track. See Care & Cleaning.