Frigidaire FFHB2740PS オーナーマニュアル

Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.

15

  1  Remove handles from carton 

and any other protective 

packaging.

  2  Position fresh food handle 

end over upper and lower 

pre-installed shoulder bolts 

(A) that are fastened into 

door, ensuring the holes for 

the set screws are facing 

towards the opposite door.

  3  While holding handle firmly

against door, fasten upper 

and lower Allen set screws 

(B) with supplied Allen 

wrench.

  4  Repeat steps 2 and 3 to install 

opposite handle. Ensure the 

holes for the set screws are 

facing towards the first door.

  5  Position freezer handle end 

over left and right pre-

installed handle mounts that 

are fastened to the door, 

ensuring the holes for the set 

screws are facing down.

  6  While holding handle firmly

against door, loosely tighten far 

right Allen set screw (B) with 

supplied Allen wrench until 

there is no gap between handle 

and door.

  7  Still holding the handle firmly to

the door, firmly tighten far left

Allen set screw (B) with supplied 

Allen wrench.

  8  Return to the far right Allen set 

screw (B) and firmly tighten

with supplied Allen wrench.

  9  Firmly tighten the inside Allen 

set screws.



All set screws should be tightened so the screw is below 

the surface of the handle. The handles should be drawn 

tight to freezer and refrigerator doors with no gaps. 

Opening the opposite door while tightening the Allen 

screw makes installation easier.
The door handle may loosen over time or if it was 

installed improperly. If this happens, tighten the set 

screws on the handles.